IONIQ 6SW

LEAK DETECTOR FOR HIGH VOLUME PRODUCTION FOR BATTERY POUCH AND MORE…

On the basis of its well proven concept of production line QC Testers, ATEQ has developed a new leak tester designed for the specific requirements of high volume production of plastic parts. This instrument is used for the detection of localized molding faults, insufficient membrane thickness, perforations, etc. This instrument has also proven to be effective on testing pouch battery cells.

The IONIQ is based on discharge current measurement and is able to detect defects up to of 10µm.

IONIQ 6SW: APPLICATIONS

EMOBILITY
- Battery Packs
- Pouches & Cells
- Modules
- Housing…

PACKAGINGS
- Aerosol Caps
- Plastic Bags
- Sprays
- Plastic Bottles…

ELECTRONICS
- Hard Disk
- Watches
- TV Screen
- Camera Lenses…

MEDICAL
- Blister Packs
- Fluid Bags
- Filters
- Condoms…

IONIQ 6SW : FEATURES

Integrated ionising high voltage generator
Integrated and adjustable according toapplication (5 to 27.3 kV)
Reject levels as % of nominal voltage (0 to 100%)
Monitoring and protection of high voltage generator
Limitation of the current rating
Speed: Minimum cycle time 0.6s
I/O’s for instrument control and results
32 programs
Measuring box and remote control
Timestamp, language selection, test customization

IONIQ 6SW: SPECIFICATIONS

PHYSICAL
- Box Dimensions and Weight
- Dimensions : H x L x P = 350x200x250 mm
- Weight : 9.4 Kg
- Remote Control Dimensions and Weight :
- Dimensions : (WxHxD) 250x250x60 mm
- Weight : 2.8 Kg
ELECTRICAL SUPPLY
- 90 V TO 240 V AC
- Single phase : 50-60 Hz – 45 W
- This instrument needs a good ground connection
TEMPERATURE
- Operating : + 10°C at + 45°C
- Storage : 0°C at + 60°C

INTERFACE
Programming via remote control 7 inputs / 5 outputs for PLC controlled applications.
- Inputs : Optically isolated.
  24 V – 10 mA maximum or dry contact.
- Outputs : Relay output
  Rated 48 V / 200 mA maximum.
OPTIONAL
- Save results
- Standard resistor box with 2 values

IONIQ 6SW: TECHNOLOGY

A high voltage loaded sharp end is applied next to an earth connected base and in between lays the plastic part we test. Should a hole exist in the part, ions will start moving from the earth to the sharp end. This will result in a loss of power and be translated into a leak.

While this method does not quantify the leak rate in terms of cc/min for example, it is the fastest ever invented to detect a leak in a go / no go process. We have achieved cycle times of less than 7/10 of a second.

Leak Ranges: Depends on the size of the hole and the material of the part

Accuracy: Depends on the size of the hole and the material of the part

The IONIQ measures the current flowing between a patented charged probe and a ground plate placed under the part to be tested.
The IONIQ uses the % of the nominal voltage (which reflects the discharge current), measured on the part as PASS/FAIL level.
In a PASS situation (fig 1) : No hole, no weak part, the IONIQ measures a high %. The measured voltage and the nominal voltage are virtually equal. The result is above the reject level, the part has passed the test
In a FAIL situation (fig 2) : The IONIQ measures a low %. The measured voltage is significantly below the nominal voltage. The result is below the reject level, the part has failed the test.
Test limitations: short probe-part-plate distance, electrical insulation from environment.

IONIQ 6SW: DOCUMENTATION